40W 850-1200mA 9-42V TRIAC Himmennettävä aLED Virtalähde

AURA+ ALCC040 LED DRIVER SERIES - ALCC040-01200-042-TRIAC

SMALL-SIZE CONSTANT CURRENT LED DRIVER WITH TRIAC DIMMING

FEATURES
• Single channel output, output current level selectable by DIP S.W.
• Support Leading edge (Triac) and Trailing edge (ELV) dimmer
• Built-in active PFC function
• Class 2 power supply. Full protective plastic housing
• Dimming effect smooth, no flicker
• Protections: Short circuit, over load, over voltage
• Small Size
• Half Potted Electronics
• IP20
• With Wires
APPLICATION
• Downlights, Panel Lights, Spotlights, Ceiling Lights, Decorative Lights, Floor Lights, Track Lights and Flood Lights

IP luokitus

IP20

Vakiovirta

850mA

900mA

950mA

1000mA

1050mA

1200mA

1100mA

1150mA

Techical Data

Output:

DIP Switch Technical Values

• 850mA 9-42V 35.7W
• 900mA 9-42V 37.8W
• 950mA 9-42V 39.99W
• 1000mA 9-40V 40W
• 1050mA 9-38V 39.9W
• 1100mA 9-36V 39.6W
• 1150mA 9-34V 39.1W
• 1200mA 9-33V 39.6W

Channel: 1
No load output voltage: 48V Max
Turn On Delay Time: <1.5s, at 230Vac (When the light begins to shine)
Current Tolerance: ±5%
Ripple Current: <3%

Input:

Voltage: 220-240VAC
Frequency: 50/60Hz
Efficiency: 86%@230VAC, Full load 83%@230VAC, Full load0.95@230VAC, Full load >0.94@230VAC, Full load
THD(full load): <15%@230VAC, Full load <20%@230VAC, Full load
AC Current (Max): 0.3A max @100VAC 0.23A max @230VAC
Inrush Current (Max): Cold start,15A@230VAC

Protections:

Over Voltage: Close output, recovers automatically after fault removed
Short Circuit: Close output, recovers automatically after fault removed
Over load: When the output voltage is exceeded, decreases and, recovers automatically when the load is reduced.

Dimming:

Dimming type: TRIAC
Dimming range: 5%-100% Dimming to off

Environment

IP rating: IP20
Working temp.: -20 ~+50°C
Storage Temp.: -40°C~85°C
Tc.: +90°C
Relative humidity: 20~90% RH

Others

Lifetime: 50,000h@tc:85°C
Switch Cycle: >25,000 times
Material: PC

Dimensions:

Lenght: 121mm
Width: 44mm
Height: 26.5mm
Lenght of the wires: 150mm
Stripping Length: 10mm
Weight: 156g

Safety:

Surge: L-N:1KV
Withstand Voltage: I/P-O/P: 3000VAC/1min/5mA
Safety standards: EN61347, GB19510
EMI Eission: EN55015, EN61000-3-2
EMC Immunity: EN61000-4-2, 3, 4, 5, 6, 8, 11; EN61547

Cautions:

1. This product should be installed by qualified personnel.
2. This product is non waterproof, need to avoid sun and rain.In case of outdoor use, please ensure it is mounted in a water proof enclosure. 3.Good heat dissipation conditions extend product life.Please install the product in a well-ventilated environment.
3. Please make sure LED power supply output voltage, current is used to meet the product requirements.
4. Please ensure that adequate sized cable is used from the controller to the LED lights to carry the current. Please also ensure that the cable is secured tightly in the connector.
5. Due to safety concerns, PVC or rubber cord of 0.75-2.5mm2 is recommended for input and output terminal(s) (excluding signal terminals). Flat power cord is not suitable.Ensure all wire connections and polarities are correct before applying power to avoid any damages to the LED lights.
6. In case of malfunction, do not repair it yourself.